Clients can use green laser pointer to hide screen
Lenses to be placed on the lens paper, to avoid injury. Do not put the lens on hard or rough surfaces, the lens is easily scratched. Gold or copper surfaces not clean and touch. Because prolonged use of equipment, dust in the air will be adsorbed on the focusing mirror and the crystal-side surface, the light reduces laser power, resulting in severe heat-absorbing optical lens, which burst. When the laser power drops, such as the power supply is working properly, you should carefully check the optics. Air ball with floating objects to blow off the surface of the lens. The light of green laser pointer can be adjusted.
Note: Do not use compressed air plant, because it contains a lot of oil and water, oil and water in the coating film formed on the surface to absorb harmful. Anhydrous ethanol (AR) and ether (AR) by the ratio of 3:1 mixture (or with acetone or ethanol), the quartet built a small lens cleaning paper box sandwiched between four fingers moistened lens cleaning paper one hand and the lens in one hand and paper coating lines in the direction of the lens lightly grazed, if not clean, repeat the above action for paper. Or a mixture of long-fiber cotton swab or immersion, gently scrub the surface of the optical lens, smear each side, to be replaced once a cotton swab or lens paper. Note: If this step does not remove the dirt, it is recommended for a lens. Application of 100mW green laser pointer contains the lecture and meeting.
Screws removed in Figure 2-2-2, 2. See Figure 2-2-1, the roof (140), the upper head (I), the upper head (II), on the end of the first (I), on the tip (II) and two pump lights with vertical lift . For the decentralization of the roof top level, remove both ends of the light gland, careful to gently pump light along the axial direction out. The new pump light along the axial load gently, so that light out of the same length at both ends, put O-ring will be installed at both ends of light gland, pressed, and then the original roof and other components also good , pressed. The whole process to avoid touching other optical devices, and adjust the device to avoid the relative position change. Note: to avoid damage to the British glass. Starting within the circulatory system, check the phenomenon of cavity no leakage of water, the pump light for the process is completed. 50mW blue violet laser pointer can send out the laser light of several kinds of laser patterns.
Assembled laser condenser chamber, first remove the seat and half of all anti-anti-membrane diaphragm seat. The hole diaphragm rod sets were put on both ends of the crystal, and transferred to the light direction coaxial with the axis of YAG crystal, which indicates the crystal rod through both sets of light across the aperture hole, and on white paper presents a round red spot, (the crystal filter light reflected to the instructions on the point raised to coincide with the holes on the filter so far). Diaphragm into the other hole 45 o semi-reflecting mirror holes on the seat, check both ends of the hole through the lens aperture is the direction of light through the mirror hole centers, namely, whether the three holes in a straight line, If the offset were adjusted 45 o and a half block or counter-mirror condenser chamber, until the three holes in a straight line alignment. The 200mW green Laser Pointer company has added several more production lines of green laser pointer .
The semi-anti-diaphragm on rack rails, locking, the light reflection and instruction set of points transferred to the crystal rod within the aperture hole at one end. Will be fitted with all-trans membrane rack rails, locking, the light reflection and instruction set of points transferred to the other side of the crystal rod within the aperture hole. Remove the three hole diaphragm. Open the main power, the laser output energy transferred to a lower value, fine-tuning of all-trans membrane rack, the use of photo-conversion film and exposure to observe the rules of the laser beam into a circle. If there is lack of clearance around the spot, then adjust the right frame of all-trans diaphragm adjustment screw. At least one production line of green laser pointer should be added for more orders of green laser pointer .
related green laser pointer blog:
laser pointer pen